CortecLogo3dlt.gif iso.gif

EcoPrimer™ is a core shell acrylic modified alkyd emulsion with bio-based primer. EcoPrimer™ provides good adhesion, salt spray resistance, and extremely low VOC. EcoPrimer™ has a fast drying time (20-30 minutes dry to touch). Its water-based formulation makes it easier to comply with environmental regulations governing solvents and VOC limits. Clean up is easy by using soap and water.

• 30% bio based
• Water-reducible
• VOC compliant
• Fast drying
• Excellent adhesion
• Extremely low VOC

EcoPrimer may be applied by spray or brush. A film thickness of 1.5-4.0 dry mils (37.5-100 microns) is recommended. The coating dries to touch in 20-30 minutes; however it takes approximately one week before the coating is fully cured. Topcoats can be applied between 30 minutes and 8 hours after the primer is applied, depending upon the type of top coat and the drying conditions.

Metals Protected:
• Carbon steel
• Stainless steel
• Galvanized steel**
• Aluminum**

** A wash primer such as VpCI®-373 green applied at 0.5-1.0 mils (12.5-25 microns) is recommended before applying the EcoPrimer to these substrates.
EcoPrimer is available in 5 gallon pails (19 liters), 55 gallon (208 liter) drums, or 275 gallon (1040 liter) totes.

Do not allow product to freeze.
View Product Data Sheet


View Editorials and Technical Articles

View Safety Data Sheet



Cortec®, MCI®, VpCI®-126 Blue®, EcoFilm®, EcoWorks®, Rawn® and Bull Frog® are registered trademarks of Cortec Corporation.

Last modified: June 07 2017 05:43:48.