|
|
|||
|
||||
|
||||
|
MATERIAL SAFETY DATA SHEET THE CORTEC CORPORATION 4119 WHITE BEAR PARKWAY ST. PAUL, MINNESOTA 55110 PHONE: 651-429-1100 OR TOLL FREE 1-800-4-CORTEC FAX: 651-429-1122 EMERGENCY PHONE NO.: CHEMTREC (FOR SPILL, LEAK, FIRE, EXPOSURE OR ACCIDENT): 1-800-424-9300 (DAY OR NIGHT) * * * * * * * * * * * * * * * * * VpCI™-337 F * * * * * * * * * * * * * * * * SECTION I - PRODUCT IDENTIFICATION PRODUCT NAME: VpCI™-337 F PRODUCT DESCRIPTION: USDA and FDA acceptable proprietary blend of corrosion inhibitors. SECTION II - HAZARDOUS INGREDIENTS
Carcinogenic: OSHA = no NTP = no IARC = no SECTION III - PHYSICAL DATA COLOR: Clear/hazy amber to brown PHYSICAL FORM: Liquid NON-VOLATILE (weight): 12-14% ODOR: Alcohol FREEZING POINT: N.E. BOILING RANGE: N.E. pH: 7.5-8.5 (Neat) EVAPORATION RATE: N.E. MELTING RANGE: N.A. DENSITY: 7.6-7.8 lb/gal (0.91-0.93 kg/l) SECTION IV - FIRE AND EXPLOSION DATA HMIS FLAMMABILITY RATING: 3 FLASH POINT: 80ºF (27ºC) FLAMMABLE LIMITS: LEL: N.E. UEL: N.E. EXTINGUISHING MEDIA: Water, carbon dioxide or other dry chemical fire fighting agents. UNUSUAL FIRE AND EXPLOSION HAZARDS: None. SPECIAL FIRE FIGHTING PROCEDURES: Firefighters should wear self-contained breathing apparatus. SECTION V - HEALTH HAZARD DATA EMERGENCY AND FIRST AID PROCEDURES: Eye Contact: Flush eyes with large amounts of water. Consult a physician immediately. Skin Contact: Wash affected area with soap and water. If irritation persists, consult a physician. Inhalation: Remove to uncontaminated area, administer oxygen if necessary. If victim has stopped breathing begin CPR. Get medical attention. Ingestion: If swallowed, give water or milk and induce vomiting. Get immediate medical attention. MEDICAL CONDITIONS PRONE TO AGGRAVATION BY EXPOSURE: None known PRIMARY ROUTES OF ENTRY: Inhalation, skin and eye contact. HEALTH HAZARDS (acute and chronic) / EFFECTS OF OVEREXPOSURE: 1. Contact of eye tissues with liquid and/or high vapor concentrations can be irritating. 2. Repeated or prolonged contact with liquid may cause mild skin irritation. 3. Inhalation of product vapors and/or particle mists resulting from the use of this product should be avoided. Inhalation of concentrations greater than 1000 ppm of ethyl alcohol may cause headache, drowsiness, lassitude and irritation to the nose and the throat. Exposure to 5,000-10,000 ppm of ethyl alcohol can cause irritation to mucous membranes. 4. Ingestion of this product may be harmful. SECTION VI - REACTIVITY DATA STABILITY: Stable HAZARDOUS POLYMERIZATION: Will not occur. HAZARDOUS DECOMPOSITION PRODUCTS: Oxides of carbon and nitrogen. INCOMPATIBILITY: Strong acids, alkalis and oxidizing agents. CONDITIONS TO AVOID: Contact with incompatible materials. SECTION VII - SPILL OR LEAK PROCEDURES STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: SMALL SPILL: Absorb on sweeping compound or other absorbent material. LARGE SPILL: Eliminate all ignition sources. All persons not wearing protective equipment should be excluded from area of spill until cleanup has been completed. Stop spill at source, dike area of spill to prevent spreading, pump liquid to salvage tank. Remove remaining liquid on sand, clay, earth, floor absorbent, or other absorbent material and place in containers. WASTE DISPOSAL: SMALL SPILL: Allow volatile portion to evaporate in hood. Dispose of in accordance with applicable regulations. LARGE SPILL: Destroy by liquid incineration. Contaminated absorbent may be deposited in a landfill in accordance with existing Federal, State and Local environmental regulations. SECTION VIII - SAFE HANDLING AND USE INFORMATION RESPIRATORY PROTECTION: A NIOSH approved respirator to remove vapors or mists. PROTECTIVE GLOVES: Chemical resistant rubber or plastic. EYE PROTECTION: Safety glasses/splash goggles. OTHER PROTECTIVE EQUIPMENT: Eye wash station. SECTION IX - SPECIAL PRECAUTIONS AND STORAGE PRECAUTIONS TO BE TAKEN IN HANDLING: Avoid contact with skin and eyes. Avoid inhalation of vapors. PRECAUTIONS TO BE TAKEN IN STORING: Do not attempt to clean since residue is difficult to remove. Completely drain "Empty" drums , properly bung and promptly dispose in an environmentally safe manner and in accordance with governmental regulations. Recycle drums only through qualified reprocessing organizations. SECTION X - SHIPPING DATA T.S.C.A. STATUS: Listed UN/NA NUMBER: 1170 DOT/IATA/IMDG SHIPPING NAME: Ethanol solution DOT/IATA/IMDG HAZARD CLASS.: 3 PG III or 3.3 DOT/IATA/IMDG REQUIRED LABELS: Flammable liquid IMDG Code Page (Amdt. 27-94): 3337-1 TECHNICAL SHIPPING NAME: N.A. PREPARED BY: Mike Hobday, Technical Service Engineer APPROVED BY: Margarita Kharshan, Lab Director DATE PREPARED: 3/12/02 SUPERSEDES: 3/22/01 DISCLAIMER: This information is furnished without warranty, expressed or implied, except that it is accurate to the best knowledge of the Cortec Corporation. The data on this sheet relates only to the specific material designated herein. The Cortec Corporation assumes no legal responsibility for use or reliance upon this data. N.E. = NOT ESTABLISHED N.A. = NOT APPLICABLE |
|||||||||||||||||||||||||
| [About Cortec] [What's New] [Publications] [Products] [Contact Us] [Related Links] [International] | ||||||||||||||||||||||||||